Minelab EXPLORER II Instrukcja Obsługi Pobierz pdf (Strona 29)

THE MINELAB EXPLORER II

BATTERIES

Recharging NiMH battery pack with the mains charger

Figure 3.3

The Explorer II is provided with a sealed Nickel Metal Hydride

(NiMH) battery pack and a charger which plugs into a

conventional wall socket.

NOTE The NiMH battery pack supplied with your detector

comes in the discharged condition. It is necessary to charge

it as explained below before operating the detector. The

batteries will reach their full capacity after several charge/

discharge cycles.

STEP 1 Remove battery pack as per instructions on previous

page.

STEP 2 Insert the mains charger plug into the socket at the

tapered end of the battery pack.

STEP 3 Plug the mains charger into the wall socket and turn on

the switch (if switch available). Leave for about 18 hours

to fully recharge.

STEP 4 Remove the battery charger plug from the battery pack.

Slide the pack back into the handle assembly battery

compartment until it clicks into place.

Figure 3.3 Recharging NiMH battery pack

THE BATTERY PACK

Do not attempt to disassemble

the NiMH battery pack. If

disposing of pack, do not

incinerate. Contact your local

authorities to enquire about

disposal or recycling facilities.

Safety Tip

Minelab’s batteries can be left on

the battery charger indefinitely

without harming the battery.

Recharging

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 111 112

Brak uwag

Minelab EXPLORER II Instrukcja Obsługi Strona 29