Minelab EXPLORER II Instrukcja Obsługi Pobierz pdf (Strona 19)

THE MINELAB EXPLORER II

ASSEMBLY

THE SHAFT ASSEMBLY

The shaft assembly is made up of the upper and lower shafts connected by the shaft

camlock. The assembly houses the coil cable and connects the search coil to the handle

assembly. These instructions assume that the search coil is connected to the lower shaft.

Shaft assembly

Figure 2.4, 2.5

To assemble the lower and upper shaft:

CAUTION Release the shaft camlock lever before inserting

the lower shaft.

STEP 1 (Figure 2.4) Feed the coil cable which is inside the lower

shaft through the inside of the upper shaft.

STEP 2 (Figure 2.5) Slide the lower shaft entirely into the upper

shaft until the camlock rests against the yoke.

STEP 3 Pull the coil cable’s metal connector through the open end

of the upper shaft until it ‘dangles’ from the opening.

You are now ready to connect the shaft assembly to the

handle assembly.

THE SHAFT ASSEMBLY

Figure 2.4 Feeding coil cable into upper shaft

Figure 2.5 Sliding lower shaft into upper shaft

Search Coil

Shaft Camlock

Upper Shaft

P0602-A

Camlock Released

P0601-A

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 111 112

Brak uwag

Minelab EXPLORER II Instrukcja Obsługi Strona 19