Minelab EXPLORER II Instrukcja Obsługi Pobierz pdf (Strona 28)

THE MINELAB EXPLORER II

BATTERIES

www.minelab.com

Removal of battery pack

Figure 3.1

CAUTION Ensure that the detector is turned OFF before

proceeding with any of the following directions.

STEP 1 Prop or rest the detector on a stable flat surface.

STEP 2 Lift the rubber cap of the battery handle assembly.

STEP 3 Raise the yellow tab. This releases the spring loaded

battery pack.

STEP 4 Remove battery pack entirely from handle assembly.

Replacing alkaline batteries

Figure 3.2

STEP 1 Remove alkaline battery pack from handle assembly. Slide

the battery pack lid in the direction of the arrow to remove.

Place 8 x ‘AA’ cell alkaline batteries inside. Make sure that

they are aligned as indicated on the label.

STEP 2 Replace the battery pack lid and slide the pack into the

compartment until it ‘clicks’ into place.

STEP 3 Replace the rubber cap, sealing the battery compartment.

NOTE High quality alkaline batteries are recommended to

optimise detector usage time. Rechargeable alkaline

batteries may be used but must be removed and recharged

separately. Check fitment of rechargable batteries prior to

purchase.

NOTE

THE BATTERY PACK

Figure 3.1 Removal of battery pack

Figure 3.2 Replacing alkaline batteries

The Explorer II has both Alkaline and NiMH battery packs available as either standard

or accessory items. Removal instructions apply to both types of pack. Battery

installation instructions apply to alkaline battery replacement only.

THE BATTERY PACK

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 111 112

Brak uwag

Minelab EXPLORER II Instrukcja Obsługi Strona 28