Minelab X-Terra 505 Instrukcja Obsługi Pobierz pdf (Strona 34)

64

65

sounds

Start Up Sequence

When the detector is turned on, there is

a short three note tune during its start up

sequence.

Positive Acknowledgement

The detector emits a short beep for every

accepted key press.

Negative Acknowledgement

The detector emits a low double beep to

indicate an invalid keypress.

Patterns Erased / Factory Preset

A six note tune will announce when these

settings are complete.

Low Battery Shutdown

A long announcement tune (descending

tones) will sound just before the detector shuts

down.

Target Response

This is the sound given by the detector when a

target is located and not discriminated against

(rejected). Generally a target that is highly

conductive (e.g. a large silver coin) emits a

high tone beep. A low tone beep is produced

for ferrous targets.

Pinpoint Response

When in pinpoint, the detector emits a variable

tone, that increases in pitch and volume as the

coil gets closer to the target.

Error

A six note tune will sound to indicate a

detector error (Error Messages, p. 66).

Overload

If the coil is passed across a large shallow

target, the detector will give a repeating

buzzing sound. This indicates that the target

signal is too strong for the detector to

interpret.

Low Battery Signal

When the battery power becomes low,

there will be a short announcement tune

(descending tones) every 60 seconds.

Noise

A random jittery sound indicates that the

detector is picking up external interference.

Sensitivity or Noise Cancel should be adjusted.

False Detections

A partial or chopped non-repeatable signal.

Two dashes will indicate on the LCD to

indicate a rejected target.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 40 41

Komentarze do niniejszej Instrukcji

Brak uwag