Minelab Musketeer ADVANTAGE Instrukcja Obsługi Pobierz pdf (Strona 11)

Page 11 The Minelab Musketeer Advantage

Installation of NiMH Battery Pack

a) Ensure your NiMH pack is fully charged.

b) Place the base of the battery pack at the

rear of the battery compartment (A). Push

the front edge of the battery pack into

position (B). The two battery clips will

“click” into position to hold the battery

pack in place (Fig 7).

NOTE:

The NiMH battery pack is factory sealed

and does not open.

Low Battery Warning and NiMH Recharging

When the batteries are reaching the point at which they will no longer operate

the Advantage will emit a distinct sharp “pip” from the speaker, approximately

every 30 seconds. When this tone is heard, it is recommended that the NiMH

battery pack be recharged or alkaline batteries be replaced as soon as possible

to avoid missing any targets.

The NiMH battery pack can be recharged using either a mains powered

charger or a 12V charger that can be plugged into the cigarette lighter of your

vehicle. These accessories are available from your authorised Minelab dealer.

CAUTION

Check the mains charger voltage. Only use the appropriate mains

charger for the country you are in.

Figure 7 - Battery

pack installation

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17 18 19

Brak uwag

Minelab Musketeer ADVANTAGE Instrukcja Obsługi Strona 11