Minelab Metal Detector II Instrukcja Użytkownika Strona 23
- Strona / 30
- Spis treści
- BOOKMARKI
Oceniono. / 5. Na podstawie oceny klientów
THE MINELAB EXPLORER II
59
QUICKSTART
5
PINPOINTING THE OBJECT
Introducing Pinpoint
Figure 5.20. See also Pinpoint overview in Chapter 4: Control Panel, page
34.
During normal operation the Explorer II operates with discrimination
settings like Iron Mask or targets chosen from the Select target list.
When the approximate location of a target has been determined, it is
necessary to identify the object’s exact position. This is done using
the Explorer II’s Pinpoint function.
Enabling Pinpoint instructs the Explorer II to temporarily disengage
discrimination and become an ‘all metal’ detector. This means that
objects normally discriminated against will emit a target signal when
beneath the coil.
For example, Iron Mask is activated and the Explorer II has
detected the approximate location of a non-ferrous coin but ignored
the rusty nail buried nearby. Selection of Pinpoint instructs the
Explorer II to respond to all metals positioned directly beneath the
coil. Now, instead of a single signal for the coin the detector will also
respond to the nail.
It should be noted that the Pinpoint function is designed to zone in on
a target with subsequent passes. For this reason it is recommended
that you maintain the same sweep height above the target and not to
pass repeatedly back and forth across the target at various heights.
This incorrect method can cause the detector to desensitize and
reduces the depth of Pinpoint. If this happens, remove the coil from
the area of the target for a few seconds so its sensitivity can recover.
For this reason, Minelab recommends Pinpoint is only used
once the approximate location of a target has been
determined. The display screen’s Pinpoint indicator will flash to
remind you to turn Pinpoint off before resuming normal detecting.
Instructions for the use of Pinpoint appear on the following page.
Figure 5.20 Pinpoint shortcut button
PINPOINTING THE OBJECT
- Quickstart 1
- GETTING STARTED 2
- Display memory 2
- BEGINNER USE 3
- Audio Overload 3
- QUICKSTART DISPLAY 4
- QUICKSTART’S SMARTFIND 6
- Discrimination 7
- Introducing Discrim 8
- THE IRON MASK 9
- Iron Mask Shortcut 9
- Operating in Iron Mask 10
- QUICKSTART’S DIGITAL DISPLAY 11
- Preferred Display 11
- MODIFYING THE DISPLAY 12
- ADJUSTING SENSITIVITY 13
- Noise Cancel 13
- ADJUSTING THRESHOLD 14
- Display Icon 14
- AUDIO RESPONSE 15
- Headphones Caution! 15
- AUDIO MENU 16
- Headphones 16
- AUDIO: ADJUSTING THE VOLUME 17
- THE MINELAB EXPLORER II 18
- AUDIO: ADJUSTING THE TONE 19
- AUDIO: ADJUSTING THE SOUNDS 20
- PINPOINTING THE OBJECT 23
- RECOVERING THE OBJECT 25
- Fill your holes! 25
- SELECTING TARGETS 26
- ADVANCED MODE OPTION 29
Powiązane produkty i podręczniki dla Pomiary, testowanie i kontrola Minelab Metal Detector II
(40 strony)
(25 strony)Indesit PFT 8H4X.R manuels
Manuels d'utilisation et guides de l'utilisateur pour Non Indesit PFT 8H4X.R.
Nous fournissons des manuels en pdf 1 Indesit PFT 8H4X.R à télécharger gratuitement par type de document : Mode d'emploi
Komentarze do niniejszej Instrukcji