Minelab F3 Instrukcja Obsługi Pobierz pdf (Strona 34)

F3 INSTRUCTOR NOTES

Minelab Countermine Division Safety Through Excellence

An example of an Operator Confirmation Exercise Sheet is included at the end of these

Instructor Notes.

Equipment

Cleared evaluation area – constructed as one mine lane (1m wide and 5m long) Targets to

bury in the test area as described below – if inert mines are not available, F3 test pieces

buried at varying depths will suffice

WARNING

If inert mines are to be used for the evaluation, ensure each mine is

certified as free from explosive (FFE).

Confirmation

Each student is to complete the confirmation exercise which will comprise:

 Opening a packed detector and preparing it for operation.

 Correctly completing the Standard Procedure. Complete Optional Procedure is

required.

 Enter the training lane and correctly sweep the coil, pin-point and mark targets.

 Repack the detector into its hard case.

• Sweeping drill. Ensure the students sweep with the coil parallel to the ground, and as

close as possible to the ground (observe local procedures) and that they overlap the

front, rear and sides of the area by one half coil width (100mm/4ins). In addition as they

progress up the training lane, they should advance the coil one half coil width

(100mm/4ins). When a target is initially detected, always sweep beyond the sound of

the target to cleared ground before commencing pinpointing procedures.

1 2 ... 29 30 31 32 33 34 35 36

Brak uwag

Minelab F3 Instrukcja Obsługi Strona 34